Welcome to factory & industry
Senthur Power has the expertise in Dismantling, Erection, Testing and Commissioning of Captive & Thermal Power plants up to 150 MW. SPSPL having verst experience Mechanical, Electrical, Control and Instrumentation of Thermal and Captive Power Plants where we offer Basic and Detail Engineering of complete BTG and BOP packages, Erection Support, Testing and Commissioning of complete Power Plant.
Our Services also include operation and maintenance of complete Power Plant. We provide fully integrated power plant Erection and commissioning services to optimize plant performance and generate higher profits to our clients.
- Turbine
- Generator
- Gear Box
- CEP, BFP, Lube oil, Condensate and Feed Pumps
- STG installation & Alignment
- Installation of Auxiliary Equipment
- Installation of BOP and its Auxiliaries
- Control Oil Connection to ESV Control HP system
- ESV Control HP stroke checking
- Turbine Insulation
- Baring Gear Setup
- Vacuum Pulling
- ESV Protection check
- Steam admission & STG Rolling
- Turbine Rotors, Diaphragms, Guide Blade Carriers including Re-blading, Rotor Refining and dynamic balancing of rotors
- High Speed and Low Speed balancing of Turbine Rotors.
- Repair and Replacing Gland Fins of Steam Glands.
- Rebabbitting and Machining of Journal Bearings and Thrust Pads.
- Feed Water heaters (HP & LP heaters).
- NDT and RLA Studies.
- HP Valve and LP Valve Hunting
- Poor Vacuum
- High Vibrations
- Evaluation and improvement in performance of rotating equipment
- Bearing Temperature
- Guide Blades, Moving Blades, Diaphragms/Guide Blade Carriers, Casing Parting Plane Fasteners.
- Journal bearings of Cylindrical, Two Lobe, Four Lobe, Tilting pads, Sleeve bearings and Thrust bearings
- Governing System-Spindles, Valve Cones, Bolts, Complete Yoke Assembly, Servomotor & Pilot valve assemblies.
- Pinion & Gear wheel shafts for Gear boxes.
- Pump Cartridges, Impellers & Shafts
- Maintenance and Inspection of Turbine, Gearbox, Generator. CEP, BFP, Lube oil, Condensate and Feed Pumps
- Configuration/Programming of AVR, Woodward Governing & Vibration Monitoring Systems
Mechanical Supervision includes
- Opening of bearing covers and Inspection of bearings and clearances
- Inspection and cleaning of throttle valves, ESV and LP valve
- Inspection of Bearings, ESV, LP valve, MOP and EOP
- Functioning of HP and LP actuators, Steam Ejector, CEP, GVC, Condenser, Oil centrifuge and Control Volves
- General checking of Auxiliary Oil Pump, Emergency Oil Pump, Auxiliary Control Oil Pump. Main Oil Pump. Main Control Oil Pump, Actuator motor. Barring motor, Vapour Extractor and all couplings Oil testing and setting of oil pressures
- Checking of Accumulator pre-charge pressure of Nitrogen
Electrical Supervision
- STG Control and Generator Protection panels.
- STG and Boiler control automation.
- NGR and LAVT panels.
- Supervision of Control and Breaker Panel.
- Inspection of instruments and providing the inputs of calibration requirement.
- Relay panel testing.
- Generator testing.
- Switch yard and equipment’s testing.